Bootstrap Cycle

a bootstrap system, which is a modification of the simple system. As shown in the figure, this system consists of two heat exchangers (air cooler and aftercooler), in stead of one air cooler of the simple system. It also incorporates a secondary compressor, which is driven by the turbine of the cooling system. This system is suitable for high speed aircraft, where in the velocity of the aircraft provides the necessary airflow for the heat exchangers, as a result a separate fan is not required. As shown in the cycle diagram, ambient air state 1 is pressurized to state 2 due to the ram effect. This air is further compressed to state 3 in the main compressor. The air is then cooled to state 4 in the air cooler. The heat rejected in the air cooler is absorbed by the ram air at state 2. The air from the air cooler is further compressed from state 4 to state 5 in the secondary compressor. It is then cooled to state 6 in the after cooler, expanded to cabin pressure in the cooling turbine and is supplied to the cabin at a low temperature T7. Since the system does not consist of a separate fan for driving the air through the heat exchangers, it is not suitable for ground cooling. However, in general ground cooling is normally done by an external air conditioning system as it is not efficient to run the aircraft engine just to provide cooling when it is grounded.
Other modifications over the simple system are: regenerative system and reduced ambient system. In a regenerative system, a part of the cold air from the cooling turbine is used for precooling the air entering the turbine. As a result much lower temperatures are obtained at the exit of the cooling turbine, however, this is at the expense of additional weight and design complexity. The cooling turbine drives a fan similar to the simple system. The regenerative system is good for both ground cooling as well as high speed aircrafts. The reduced ambient system is well-suited for supersonic aircrafts and rockets.